Remote Electrical Tilt (RET) Products
The Powerwave RET system is designed to meet the high requirements for reliability, flexibility and efficiency in remote control of tower-mounted telecommunication equipment. The system consists of a Master Control Unit (MCU) that controls the Antenna Line Devices (ALDs) and supplies DC power to them via a common bus. ALDs are connected to the MCU using a separate ALD system cable or by using the existing RF feeders in your system.
RET Modules
The RET Unit is a part of the Powerwave RET System and consists of a stepping motor that can be connected to the positioning rod used for adjusting the electrical down-tilt of Powerwave MET antennas.
Antenna Tilt Configuration Files
The antenna tilt configuration files contain information needed by the RET controllers to identify which antenna type it is connected to. They also contain the necessary data about the antenna in order to set the correct tilt angle.
NetWay 7000 (MCU)
Simplifies operations by enabling remote electrical tilting of antennas and setting of TMA gain via Web or SNMP interfaces The Powerwave MCU controls, supervises and provides DC power to the Remote Electrical Tilt (RET) System via a common bus.
CILOC
The CILOC connects an RET module to an MCU using an ordinary RF feeder. It transfers DC supply and data signals to the antenna line device enabling remote electrical tilt of antennas.
RET System Cables
The RET System Cables are a part of the Powerwave RET System. They provide a direct connect option from the MCU to a RET module and are offered in a variety of lengths that can be directly connected in series to create customer lengths.